收藏本站联系我们 您好,欢迎来到济南空调维修,济南空调安装,三联家电售后服务中心!

新闻中心
当前位置:首页-新闻中心 >

关于空调移机我们会做哪些事项?

来源:http://www.jnslshwx.com 日期:2020-08-26 发布人:admin
1. 试机:对空调移机前各项功能进行测试,看运行是否正常。
1. Test run: test all functions of the air conditioner before moving it to see if it operates normally.
2. 回收制冷剂,并拆除室内外连接线。因此,若是在连接线的两端做好标记,那么装机时便不会出现连接线因接错出现故障的问题。
2. Recover the refrigerant and remove the indoor and outdoor connecting wires. Therefore, if the two ends of the connecting wire are marked, the problem of connecting wire failure due to wrong connection will not occur during the installation.
3. 连接管接口清洁:空调使用后都会附有尘垢,对连接管接口螺帽进行拆卸时,需注意清理喇叭口及接头处,避免灰尘等脏物进入到管路中,也避免移机后运行时管路出现堵塞。在安装对接接口前,对喇叭口及内侧需再度进行检查,待清除后才可盖上螺帽。如果正好遇上下雨,那么在拆开连接管之时,得用塑料袋包扎好管口,以免雨水进入从而引起冰堵。
3. Cleaning of connecting pipe interface: dust and dirt will be attached to the air conditioner after use. When removing the nut of connecting pipe interface, attention should be paid to cleaning the bell mouth and joint to avoid dust and other dirt entering the pipeline, as well as the pipeline blockage during operation after moving the machine. Before installing the butt joint, the bell mouth and inner side should be checked again, and the nut can be covered after cleaning. If it happens to rain, then when opening the connecting pipe, wrap the pipe orifice with plastic bag to avoid the rain water entering and causing ice blockage.
4. 拆卸室内机时,避免冷凝水流入线路板:因室内机接水盘和排水管内留有一些冷凝水,所以在拆卸室内机、搬运室内机时,不可将室内机装有线路板的那头朝下,或是翻转过来,需要让装有线路板的这头稍微高些,水可以从另一端流出,从而避免冷凝水被灌进线路板引起开机时的电器故障。
济南空调移机
Four When disassembling the indoor unit, avoid the condensation water flowing into the circuit board: because there is some condensed water in the water tray and drainage pipe of the indoor unit, the end with the circuit board installed on the indoor unit should not be turned down or turned over when the indoor unit is disassembled and transported. The end with the circuit board should be slightly higher, and the water can flow out from the other end, so as to avoid the condensation water being poured into the circuit The board causes electrical failure when starting up.
5. 检验连接口的喇叭口:因连接管子上的喇叭口长时间受挤压,有的喇叭口的根部存在非常深的压痕,这些喇叭口非常容易折断和拉断,或是在开机时出漏气,所以,需要将喇叭口拆卸下来,并进行检查,对于不合格的需割掉重扩,从而避开隐患。
5. Check the bell mouth of the connecting joint: because the bell mouth on the connecting pipe is squeezed for a long time, there are very deep indentation on the root of some bell mouth. These bell mouth are very easy to break and break, or leak when starting up. Therefore, it is necessary to dismantle the bell mouth and carry out inspection. For unqualified ones, cut off and expand again, so as to avoid hidden dangers.
6. 外机搬运和安装中,不可进行翻转,或有过大的倾斜角,也不可用手抓截止阀抬机。此外,移机时注意轻拿轻放,拆装过程科学进行,抽管方向合理、弯管力度适合等。
6. During the transportation and installation of the external machine, it is not allowed to turn over or have excessive inclination angle, and it is not allowed to lift the machine by hand holding the stop valve. In addition, attention should be paid to handle the machine with care, the disassembly process should be carried out scientifically, the direction of pipe drawing should be reasonable, and the bending force should be suitable.
本文由济南空调移机整理发布,您是不是对这些内容有所了解了呢?更多的内容请点击:http://www.jnslshwx.com我们会有更多精彩内容等你查看。
This article is organized and released by Jinan air conditioner. Do you have any understanding of these contents? For more information, please click: http://www.jnslshwx.com We'll have a lot more to see.

上一篇:避免日后“麻烦”,拆机后安装空调需要怎么做?
下一篇:卫生间合适安装空调吗?